Publications - International Journals

20112009-2010 2008-2007 2006-2005 2004-2003 2002-2001 2000-

DE SANTIS F; VIETRI A. R; PANTANI R. (2006). Morphology Evolution During Polymer Crystallization: Simultaneous Calorimetric and Optical Measurements. MACROMOLECULAR SYMPOSIA, vol. 234; p. 7-12, ISSN: 1022-1360

SORRENTINO A; PANTANI R.; BRUCATO V (2006). INJECTION MOLDING OF SYNDIOTACTIC POLYSTYRENE/CLAY NANOCOMPOSITES. POLYMER ENGINEERING AND SCIENCE, vol. 46; p. 1768-1777, ISSN: 0032-3888

DE SANTIS F; ADAMOVSKY S; TITOMANLIO G.; SCHICK; C (2006). Scanning Nanocalorimetry at High Cooling Rate of Isotactic Polypropylene. MACROMOLECULES, vol. 39(7); p. 2562-2567, ISSN: 0024-9297

LAMBERTI G; TITOMANLIO G. (2006). Analysis of Film Casting Process: Effect of Cooling during the Path in Air. INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH, vol. 45(2); p. 719-723, ISSN: 0888-5885

PANTANI R. (2005). Validation of a model to predict birefringence in injection molding. EUROPEAN POLYMER JOURNAL, vol. 41-7; p. 1484-1492, ISSN: 0014-3057

PANTANI R.; SORRENTINO A. (2005). Pressure Effect on Viscosity for Atactic and Syndiotactic Polystyrene. POLYMER BULLETIN, vol. 54; p. 365-376, ISSN: 0170-0839

COCCORULLO I; PANTANI R; TITOMANLIO G. (2005). Evolution of morphology of iPP in processing conditions; Relevance of solidification pressure. INTERNATIONAL POLYMER PROCESSING, vol. 20; p. 186-190, ISSN: 0930-777X

LAMBERTI G.; TITOMANLIO G. (2005). Analysis of film casting process: the heat transfer phenomena. CHEMICAL ENGINEERING AND PROCESSING, vol. 44; p. 1117-1122, ISSN: 0255-2701

LAMBERTI G; TITOMANLIO G. (2005). Interaction between light and crystallizing polymer: a simulation study. INTERNATIONAL POLYMER PROCESSING, vol. 41; p. 2055-2066, ISSN: 0930-777X

PANTANI R; COCCORULLO I; SPERANZA V; TITOMANLIO G. (2005). Modeling of morphology evolution in the injection molding process of thermoplastic polymers. PROGRESS IN POLYMER SCIENCE, vol. 30; p. 1185-1222, ISSN: 0079-6700

PONTES A.J.; POUZADA A.S.; PANTANI R.; TITOMANLIO G. (2005). Ejection force of tubular injection moldings. Part II: A prediction model. POLYMER ENGINEERING AND SCIENCE, vol. 45; p. 325-332, ISSN: 0032-3888

SORRENTINO A; PANTANI R; PICARELLA D; TITOMANLIO G. (2005). A novel apparatus for solidification of polymer samples under simultaneous high pressures and high cooling rates. REVIEW OF SCIENTIFIC INSTRUMENTS, vol. 76; p. 083901/1-083901/5, ISSN: 0034-6748